Vibration Damper: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Fig 1: Installing Crankshaft Belt Pulley With Original Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installed position: The vibration damper crankshaft hole -arrow- must be positioned over the protrusion on the crankshaft toothed belt gear.

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.