Engine Support: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Install the bolt -2- before installing the engine support in the engine support opening.

-- Install the engine support and tighten the bolts -1- to -3- hand-tight.

Fig 1: Identifying Engine Support And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts as follows to the specified tightening specification and sequence, refer to Fig 2.

-- Install the upper toothed belt guard, refer to TOOTHED BELT GUARD .

-- Install the engine mount, refer to ENGINE MOUNT .

Fig 2: Identifying Engine Support And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in steps in the sequence shown: