LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (1.8L & 2.0L - Crankshaft, Cylinder Block - Engine Code(S): CPLA, CPKA, CPPA & CPRA (Convertible)) >> 13 Crankshaft, Cylinder Block >> Removal And Installation >> Cylinder Block, Transmission Side >> Flywheel >> Removing

Cylinder Block, Transmission Side: Flywheel: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, and 2014 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Dual-Mass Flywheel & Bolts
GWWA30-0102Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
CAUTION:

Danger of causing damage to the flywheel.

  • Remove the bolts -B- by hand. Do not use an air-powered or impact wrench.
  • When removing bolts, ensure bolt head does not come in contact with the flywheel.
  • Turn the flywheel -A- until the bolts -B- line up with the holes -arrows-.

-- Place the Flywheel Retainer 3067 into the hole on the cylinder block -B-.

Fig 2: Identifying Flywheel Retainer
GWWN13-10563Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen and remove bolts for flywheel.

scientia non olet · About LEMON Manuals