Auxiliary Components Bracket: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, and 2014 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-rings and seals.

-- Coat the O-rings -4- with coolant.

Fig 1: Accessory Assembly Bracket, Coolant Pump Housing, Connection And O-Rings

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the connection -2- into the coolant pump housing -3-.

-- Slide the auxiliary components bracket -1- onto the connection and then install and tighten the bolts, refer to Figure.

-- Fill the coolant, refer to COOLANT, DRAINING AND FILLING => Filling .

-- Install the oil and check the oil level, refer to 14.2 Engine Oil, Draining or Extracting and Filling, Replacing Oil Filter.