LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (1.8L & 2.0L - Crankshaft, Cylinder Block - Engine Code(S): CPLA, CPKA, CPPA & CPRA (Convertible)) >> 13 Crankshaft, Cylinder Block >> Description And Operation >> Overview - Balance Shaft

Overview - Balance Shaft

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, and 2014 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Balance Shaft Overview
GWWA13-10964Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Bolt
    • 4 Nm +45°
    • Replace after removing
  2. Balance Shaft
    • Must be replaced after removing
    • Exhaust side
    • Lubricate the bearing with engine oil
    • Replacing, refer to BALANCE SHAFT, EXHAUST SIDE .
  3. Needle Bearing Rim
    • No replacement part, part of the balance shaft delivery package
  4. Pipe for the Balance Shaft
    • Installed position, refer to Fig 2
  5. Cylinder Block
  6. Balance Shaft Seal Intake Side
  7. Balance Shaft
    • Intake side
    • Must be replaced after removing
    • Lubricate the bearing with engine oil
    • Replacing, refer to BALANCE SHAFT, INTAKE SIDE .
  8. Needle Bearing Rim
    • No replacement part, part of the balance shaft delivery package
  9. Bolt
    • 4 Nm +45°
    • Replace after removing
Fig 2: Balance Shaft Pipe - Installed Position
GWWA13-10967Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
scientia non olet · About LEMON Manuals