LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Anti-Lock Brake System (Convertible)) >> 45 Anti-Lock Brake System >> Description And Operation >> Component Location Overview - Anti-Lock Brake System (Abs) >> Component Location Overview - Abs Mark 70

Component Location Overview - Abs Mark 70

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Anti-Lock Brake System (ABS) Components Location Overview
GWWM45-10026Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Anti-lock Brake System (ABS) Control Module -J104-
    • Component location: on the ABS Hydraulic Unit -N55- inside the engine compartment on the right side.
    • Do not disconnect connector before successfully completing On Board Diagnostic (OBD). Switch ignition off before separating connector
    • Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55- .
  2. ABS Hydraulic Unit -N55-
    • Installed location: inside the engine compartment on the right side

      The ABS Hydraulic Unit -N55- consists of the following components:

    • Anti-lock Brake System (ABS) Hydraulic Pump -V64-
    • Valve block (contains inlet and outlet valves)
    • The Anti-lock Brake System (ABS) Hydraulic Pump -V64- and valve block must not be separated from one another.
    • Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55- .
  3. Traction Control Indicator Lamp -K86-
    • Component location: inside the instrument cluster
  4. Anti-lock Brake System (ABS) Indicator Lamp -K47-
    • Component location: inside the instrument cluster
  5. Brake Pad Wear Indicator Lamp -K32-
    • Component location: inside the instrument cluster
  6. Brake System Indicator Lamp -K118-
    • Component location: inside the instrument cluster
  7. Brake Lamp Switch -F-
    • Including the Brake Pedal Switch -F47-
    • Installed location: on the master brake cylinder
    • Removing and installing. Refer to BRAKE LAMP SWITCH .
  8. Diagnostic Connection
    • Component location: driver side footwell cover
  9. Rear Wheel Bearing Unit
    • The Anti-lock Brake System (ABS) sensor ring is installed in the wheel bearing
  10. Rear Speed Sensor --
  11. Front Wheel Bearing Unit
    • The Anti-lock Brake System (ABS) sensor ring is installed in the wheel bearing
  12. Front Speed Sensor --