LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Brake System - Mechanical Components (Convertible)) >> 46 Mechanical Components >> Removal And Installation >> Rear Brake Shield >> Brake Shield, Multi-Link Rear Axle >> Installing

Brake Shield, Multi-Link Rear Axle: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

If using the brake pads again, install the marked pads in the same location.

-- Secure the brake caliper with new self-locking screws.

NOTE:

Each time after replacing brake pads, depress brake pedal several times firmly to properly seat brake pads in their normal operating position.

Check the brake fluid level after removing the brake pads.

-- Install wheel and tighten.

scientia non olet · About LEMON Manuals