Brake Caliper, Rear Brakes Bosch ZOH BIR 38: Removing
Work procedure applies only for replacing or when performing subsequent service work on brake caliper.
-- Loosen the wheel bolts.
-- Raise the vehicle.
-- Remove the wheel.
-- Push the lever on the brake caliper -2- in direction of -arrow-.
-- Disengage the brake cable -1- from the lever on the brake caliper -2-.
-- Squeeze the retainers -3-.
-- Remove the brake cable -1- from the bracket on the brake caliper -4-.
-- Connect the bleed hose -1- from the bleeder bottle to the brake caliper bleed valve and open the bleed valve.
-- Install the Brake Pedal Actuator VAG 1869/2.
-- Close the bleed valve and remove the bleeder bottle.
-- Remove the brake hose -1- and banjo bolt -2- to the brake caliper.
-- Close the brake line and threaded hole immediately using Plugs 1H0 698 311 A.
-- Counterhold the guide bolt and remove the bolts -arrows- from the brake caliper -1-.
-- Remove the brake caliper from the brake carrier.
Cleaning:
Do not blow brake system using compressed air, the dust produced is harmful to health!
Use only appropriate solvents for cleaning brake system.