Brake Cable, Disc Brakes On Twist Beam Rear Suspension: Removing
-- Loosen the wheel bolts.
-- Raise the vehicle.
-- Remove the wheel.
-- Release parking brake.
Vehicles Without Center Armrest
-- Remove the mat from the storage compartment.
-- Open access cover -1- in the center console.
Vehicles With Center Armrest
-- Remove the cover -1- on the center armrest -2-.
-- Remove the nut -1- on the center armrest -2-.
-- Remove the center armrest. Refer to REMOVAL AND INSTALLATION .
Continuation For All Vehicles
-- Loosen the adjusting nut -1- until it is possible to disengage the brake cable -2- from the compensator bracket.
-- Press the lever -2- located on the brake caliper in direction of -arrow- and disengage the brake cable -1-.
-- Squeeze the tabs -3- and remove the brake cable from the bracket -4- on the brake caliper.
-- Pull the brake cable -1- out of the retainer -arrow A- on the bracket -2-.
-- Remove the brake cable -1- from the guide -arrow B- for the mount -2-.
-- Remove the brake cable -1- bracket -2- on the rear axle -3-.
-- Disengage the brake cable -1- from the bracket -2- and pull it from the guide tube -3-.