Cover Plate, Brake Caliper FS III: Removing
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.
Do not open the brake hydraulic system when removing!
-- Loosen the wheel bolts.
-- Raise the vehicle.
-- Remove the wheel.
-- Remove brake rotor. Refer to BRAKE ROTOR, BRAKE CALIPER FS III .
-- Unscrew the threaded connection -arrows- from the cover plate -1-.
-- Remove cover plate -1-.
Cleaning:
WARNING:
Do not blow brake system using compressed air, the dust produced is harmful to health!
-- Thoroughly clean the contact surfaces on the brake carrier for the brake pads and remove any corrosion.
Clean brake caliper with mineral spirits exclusively.