Cover Plate, Brake Caliper FN 3: Removing
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.
Do not open the brake hydraulic system when removing!
-- Loosen the wheel bolts.
-- Raise the vehicle.
-- Remove the wheel.
-- Remove the brake carrier. Refer to BRAKE CARRIER, BRAKE CALIPER FN3 .
-- Remove brake rotor. Refer to BRAKE ROTOR, BRAKE CALIPER FN 3 .
-- Unscrew the threaded connection -arrows- from the cover plate -1-.
-- Remove cover plate -1-.
Cleaning:
WARNING:
Do not blow brake system using compressed air, the dust produced is harmful to health!
Clean brake caliper with mineral spirits exclusively.