Brake Pads, Brake Caliper FS III: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.

Do not Open the Brake Hydraulic System when Removing!

-- Loosen the wheel bolts.

-- Raise the vehicle.

-- Remove the wheel.

Vehicles with Brake Pad Wear Display

Fig 1: Brake Pad Wear Indicator Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1- from the brake pad wear display.

Continuation for all vehicles

Fig 2: Identifying Hose Connection

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove caps -arrows-.

-- Loosen both guide pins -arrows- and remove them from the brake caliper -1-.

Fig 3: Identifying Brake Calipers

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove brake caliper -1- and secure with wire so that the weight of the brake caliper does not stress or damage the brake hose.

-- Remove brake pads from brake caliper.

Cleaning:

WARNING:

Do not blow brake system using compressed air, the dust produced is harmful to health!

-- Thoroughly clean the contact surface for the brake pads on the brake carrier and remove any corrosion.

Use only appropriate solvents for cleaning brake caliper.