LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (2.0L - Engine Assembly - Engine Code(S): CJAA & CVCA (Convertible)) >> 10 Engine Assembly >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
Bolts and Nuts
  M5 4.5
M6 10
M7 15
M8 20
M10 40
M12 652
Bracket to Body Bolt1 - 20 + 90°
Bracket to Engine Mount Bolt1 - 20 + 90°
Engine Mount to Body Bolt1 - 40 + 90°
Engine Mount to Engine Mount Bracket Bolt1 - 60 + 90°
Engine Mount Bracket to Engine1   40 + 180°
Pendulum Support to Subframe Bolt1 - 100 + 90°
Pendulum Support to Transmission Bolt1 - 50 + 90°
Transmission Mount to Body Bolt1 - 40 + 90°
Transmission Mount to Transmission Mount Bracket1 - 60 + 90°
  • 1 Always replace
  • 2 Tightening specification for M12 collar bolt: 75 Nm

Secure Manual Transmission to Engine

Fig 1: Removing Lower Engine/Transmission Bolts
GWWA30-10043Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Item Bolt Nm
1 1) M12x55 80
2 1) M12x165 80
3 M10 x 105 40
4 M10x50 40
5 2) M12x65 80
A Alignment sleeves for centering
  • 1) Bolt with threaded pin M8.
  • 2) Install in transmission from engine side.

Secure DSG Transmission to Engine

Fig 2: Direct Shift Automatic Transmission To Engine Mounting Bolts
GWWA34-10045Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Item Bolt Nm
1, 3, 10 M12x55 80
5 M12x65 80
6, 7, 8 M10x50 40
9 M12x70 80
2, 4 Starter, securing, refer to Removal and Installation
A Alignment sleeves for centering
scientia non olet · About LEMON Manuals