Installing the Bonded Rubber Bushing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Marking Position Of Bonded Rubber Bushing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mark the position of the bonded rubber bushing on the trailing arm with a right angle.

-- Place the outer edge of the right angle on the lower -1- and upper radius -2- of the hole.

-- Make a mark over and under the bushing on the trailing arm -arrows-.

α -

90°

Position the bonded rubber bushing on the trailing arm so that the marked line -arrows- is between the raised areas -1-.

Fig 2: Positioning Bonded Rubber Bushing On Trailing Arm

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Make absolutely sure that the bonded rubber bushing is in the correct installation position in relation to the trailing arm socket.

-- Mount the tools asshown in the figure.

Fig 3: Identifying Assembly To Press In Bonded Rubber Bushing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tube T10230/5
Thrust plateT10230/12, chamfer must point to bonded rubber bushing
Bonded Rubber Bushing
Front Subframe Mount Kit 3372
Press Plate VW402

-- Press in bonded rubber bushing flush.

-- Install mounting bracket on trailing link. Refer to Removing .

-- Install trailing link. Refer to Installing .