Tension Struts: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Insert the tension struts on the markings on the body and subframe.

Fig 1: Identifying Subframe Crossbrace

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install new bolts -2- and -4- just far enough so that the tensions struts and the subframe are not touching each other.

-- Tighten the bolts -1- and -5- to the tightening specification.

-- Lower the vehicle onto its wheels.

NOTE:

Tension strut screws to subframe should only be tightened when vehicle is resting on wheels.

-- Tighten the bolts -2- and -4- to the tightening specification.