LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (2.0L - Engine Coolant System - Engine Code(S): CJAA & CVCA (Convertible)) >> 19 Engine Coolant System >> Removal And Installation >> Fan Shroud With Coolant Fan >> Removing

Fan Shroud With Coolant Fan: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER .

-- Remove the noise insulation. Refer to Description and Operation .

-- Remove the cover for the air guide; disengage the side clips to do so -arrows-.

Fig 1: Air Duct Cover Slide Clips
GWWA10-10367Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the left and right spring clips -arrow A- and disconnect the lower air guide -2-.

Fig 2: Disengaging Lower Air Guide
GWWA10-10919Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Move the lower air guide slightly to the rear and disengage the lower air guide -3-.

-- Disengage the air guide pipe -1- from the lower air guide -arrow B-.

-- Remove the air filter housing with the mass air flow sensor and connecting pipe AIR FILTER HOUSING .

-- Disconnect the connector -1-.

Fig 3: Coolant Fan Control (FC) Control Module J293
GWWA19-0473Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows-.

-- Remove the fan shroud with the radiator fan downward.