LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Cylinder Head, VALVETRAIN [DDSA, DDSB] >> 15 Cylinder Head, VALVETRAIN >> Timing Chain Cover >> Timing Chain Cover, Removing And Installing >> Upper Timing Chain Cover, Removing And Installing >> Installing

Upper Timing Chain Cover, Removing And Installing: Installing

Fig 1: Timing Chain Cover Tightening Sequence (1 of 2)
GWWA15-11235Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the seal and coat with engine oil.

-- Install the cover on the cylinder head the tighten the bolts hand tight. While doing so make sure that the seal lays correctly on the cylinder head.

-- Tighten the bolts -1 through 6- in the sequence shown. Use the : VAG1783  and the : VAG1783/1  for the bolts -3 and 5-.

-- Install the Camshaft Adjustment Valve 1 -N205- and Exhaust Camshaft Adjustment Valve 1 -N318-. Refer to Camshaft Adjustment Valve 1 -N205- AND Exhaust Camshaft Adjustment Valve 1 -N318-, REMOVING AND INSTALLING .

-- Check if the oil dipstick tube is correctly attached in the lower cover.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals