-- Tighten The Camshaft Adjuster Bolts On The Right Cylinder Head As Follows:

Fig 1: Identifying Bolts For Camshaft Adjuster Using Multipoint Socket T10035

Courtesy of AUDI OF AMERICA, LLC

-- Remove the :3242  .

Fig 2: Identifying Crankshaft Holder 3242 Into Hole, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Turn the crankshaft 2 turn in direction of engine rotation in direction of -arrow- until the crankshaft is at "TDC" again.

Fig 3: Identifying Notch -Arrow A- On T40257 Must Face Color Dash -Arrow B- On Vibration Damper

Courtesy of AUDI OF AMERICA, LLC

• The threaded holes -arrows- in the camshafts must face upward.
  Fig 4: Facing Threaded Holes In Camshafts Upward (As Shown)

  Courtesy of AUDI OF AMERICA, LLC

-- :T40070  mounted on both cylinder heads and tightened to 25 Nm -arrows-.

Fig 5: Mounting Camshaft Locating Tool T40070 To Both Cylinder Heads

Courtesy of AUDI OF AMERICA, LLC

• The :T40070  is correctly positioned when the holes for the cylinder head bolts remain free.

-- Install the :T40237  in the hole and tighten to 20 Nm.

Fig 6: Identifying Crankshaft Holder 3242

Courtesy of AUDI OF AMERICA, LLC

• The :T40237  must engage in the locating hole in the crankshaft -1-, otherwise repeat the adjustment.

-- Remove the camshaft locating pins on both cylinder heads.

-- Remove the :3242  .

-- Install the sealing plug -arrow- for the "TDC" marking in the upper part of the oil pan. Refer to OVERVIEW - OIL PAN UPPER SECTION .

Fig 7: Identifying Locking Bolt Of Upper Part Of Oil Pan

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note The Following: 

-- Install the timing chain covers. Left, refer to LEFT TIMING CHAIN COVER, REMOVING AND INSTALLING . Right, refer to RIGHT TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Install the cylinder head covers. Left, refer to LEFT CYLINDER HEAD COVER, REMOVING AND INSTALLING . Right, refer to RIGHT CYLINDER HEAD COVER, REMOVING AND INSTALLING .