Assembly Notes on HID Headlamp Bulbs
CAUTION:
- Before replacing a bulb, the corresponding consumer must always be switched off.
- Turn off the ignition and all electric consumers and remove the key.
- Do not touch glass cone of bulb with bare fingers, use clean cloth gloves. The remaining fingerprint would evaporate due to the heat of the operated bulb and condense on the reflector which would impair headlamp luminosity.
- A bulb must only be replaced with one of the same version. Bulb identification can be found on bulb socket or glass cone.
- Harness connectors must engage correctly when installed and must be checked for proper connection.