Line And Breather For Clutch Slave Cylinder

WARNING: This page is about a different car, the 2014 Volkswagen Tiguan, 2013 Volkswagen Tiguan, and 2012 Volkswagen Tiguan. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Hose/Line Assembly Or Plastic Line On Breather, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip -2- with a screwdriver or a pointed tool and remove the line -4- from the breather assembly -1-.

-- Push the line -4- and O-ring -3- into the breather valve -1- until the clip -2- audibly locks.

-- Pull on the line to make sure it is tight.

Fig 2: Bleeder At Slave Cylinder, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip -2- with a screwdriver and remove the breather assembly -4- from the clutch slave cylinder -1-.

-- Check the O-ring -3- on the clutch slave cylinder. Press in the breather at slave cylinder connector until the clip engages audibly.

-- To check, pull on the breather assembly.

-- Bleed the clutch system. Refer to CLUTCH SYSTEM, BLEEDING .