Reverse Gear Output Shaft Overview
WARNING: This page is about a different car, the 2014 Volkswagen Tiguan, 2013 Volkswagen Tiguan, and 2012 Volkswagen Tiguan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The output shaft is not available as a replacement part.
When installing the tapered roller bearing, install new shims which have the same thickness as the previous shims.
- Clutch Housing
- Oil Deflector Ring
- Adjusting Shim
- Pay attention to the thickness.
- Will get damaged when being removed, always replace.
- Outer Race/Tapered Roller Bearing
- Inner Race/Tapered Roller Bearing
- Dished Washer
- Output Shaft
- For reverse gear
- Bearing for drive gear for reverse gear as a plain bearing, or with a roller bearing -8- and needle bearing -9-.
- Differences, refer to Fig 2.
- Roller Bearing
- For reverse gear.
- not available on all transmissions, then plain bearing for reverse gear -10-.
- Needle Bearing
- For reverse gear.
- Not available on all transmissions, then plain bearing for reverse gear -10-.
- Reverse Gear
- Different internal diameters for plain bearing, the roller bearing -8- and the needle bearing -9-.
- Stop ring and spring, removing and installing. Refer to REVERSE GEAR WHEEL STOP RING AND SPRING .
- Reverse Gear Locking Collar
- With synchronizer ring.
- Reverse Gear Synchronizer Hub
- Locking Ring
- Inner Race/Tapered Roller Bearing
- Outer Race/Tapered Roller Bearing
- Adjusting Shim
- Pay attention to the thickness.
- Will get damaged when being removed, always replace.
- Transmission Housing
| Reverse Gear Bearings | |
|---|---|
| Plain bearing | Groove all the way around -arrow 1- near the hole -arrow 2- |
| Roller bearing and needle bearing | No groove all the way around -arrow 1- near the hole -arrow 2- |