Rearview Camera System
Before troubleshooting or servicing, the technicians must be familiar with the function and operation of the rear system.
Refer to the Owner's Manual.
Use "Guided Fault Finding" when servicing or performing Fault Finding with the Vehicle Diagnostic Tester, refer to the appropriate Wiring Diagram.
When the battery is connected, check the all the vehicle accessories (radio, clock, electronic conveniences, etc.) according to the repair information and/or the Owner's Manual.
The rear system assists the driver during back-up driving by providing the driver with an image of the traffic situation behind the vehicle via the monitor of the radio or radio navigation system.
The system switches itself on when the reverse gear is selected, even when the radio or radio/navigation system is switched off.
The rear view camera system consists of the following components:
- Rear View Camera -R189-,
- Rear View Camera System Control Module -J772-,
- Radio/Navigation Display Control Module -J503-,
- and steering wheel with Steering Angle Sensor -G85-.
It is not permitted to install an auxiliary license plate holder for vehicles with rear view camera system because it would impair the function of the rear view camera system. License plate lights may also be impaired.
DTC Recognition and Display
Rear view camera system is equipped with On Board Diagnostic (OBD).
Use Fault Finding on the Vehicle Diagnostic Tester.