Clutch Pedal
WARNING: This page is about a different car, the 2014 Volkswagen Tiguan, 2013 Volkswagen Tiguan, and 2012 Volkswagen Tiguan. However, it is still accessible from the selected car via links, so may be relevant.
- Bulkhead
- With a mount for the bracket.
- Gasket
- Always replace
- Between the bracket and the bulkhead.
- Self-adhesive
- Attached to the bracket.
- Mounting Bracket
- For the clutch pedal mounting.
- Some equipment versions have a sound absorber, refer to Fig 2.
- Removing and installing, refer to MOUNTING BRACKET .
- Bolt
- Over-Center Spring
- Removing and installing, refer to OVER-CENTER SPRING .
- Bushing
- Pin
- Clutch Pedal
- Removing and installing, refer to CLUTCH PEDAL .
- Mount
- When removing and installing, separate the clutch master cylinder from, the clutch pedal using the pliers T10005. Refer to CLUTCH PEDAL .
- Gasket
- Always replace.
- Between the master cylinder and the bracket.
- Master Cylinder
- Remove and install after removing the bracket. Refer to MASTER CYLINDER .
- Clutch Position Sensor -G476-
- Removing and installing, refer to Clutch Position Sensor -G476- .
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic, testing and information system VAS 5051.
- Circlip
- To remove and install the hose/line assembly or pipe, pull the clip all the way out.
- Supply Hose
- Nut, Self Locking
- 25 Nm
- Always replace
- Quantity: 3
- For the bracket to the bulkhead.
- Nut
- 25 Nm
- Always replace
- Jounce Bumper
- For the clutch pedal
Sound absorber -arrow-,