Rear Final Drive Bonded Rubber Bushings: Notes
NOTE:
The Identification (ID) -arrow- on the "bottom side" of the rear final drive identifies which final drive is installed.
Example of the ID on a final drive "02D"
Special tools and workshop equipment required
- Thrust Piece 3291/1 from the Bushing Tool Set 3291
- Spindle from the Bushing Tool Set 3292
- Thrust Pieces 3348 and 3348/1 from the Bearing Installer - Multiple Use 3348
- Puller - Kukko Internal - 46-56mm 21/7
- Puller - Kukko Counterstay 22/2