Steering Column Combination Switch -E595- Without KESSY
WARNING:
Before working on electronic system and removing the steering wheel the following conditions must be met:
- The technician must discharge static electricity. This is accomplished by touching grounded metal like, for example, water pipes, heating pipes, metal carriers or a heater pipe, refer to ELECTRICAL COMPONENTS .
If this note is ignored it can result in failure of the control modules during later operation.
- Remove the battery ground cable, refer to Battery, Starter, Generator, Cruise Control .
- Wheels must be located in straight ahead position.
If this note is ignored, it can result in failure of the airbag system during later operation.
Depending on equipment, the Steering Column Combination Switch consists of the following components and cannot be disassembled:
- Turn Signal Switch -E2-
- Windshield Wiper Switch -E-
- Cruise Control Switch -E45-
The procedure for removing and installing the Steering Column Combination Switch differs depending on the manufacturer.
- Steering Column Combination Switch, Valeo, removing and installing, refer to Steering Column Combination Switch -E595-, VALEO .
- Steering Column Combination Switch, Kostal, removing and installing, refer to Steering Column Combination Switch -E595-, KOSTAL .