Overview - Charge Air System: Notes
- Air Duct Hose
- Installing. Refer to 20.
- Rubber Bushing
- For the charge air cooler
- Left
- Bolt
- 8 Nm
- Charge Air Cooler
- Removing and installing. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .
- Rubber Bushing
- For the charge air cooler
- Right
- Bolt
- 8 Nm
- Rubber Bushing
- For lower charge air cooler in body
- Right
- Rubber Bushing
- For lower charge air cooler in body
- Left
- Seal
- Replace if damaged
- Bolt
- 7 Nm
- Air Duct Hose
- Installing. Refer to 20.
- Spring Clip
- Check for proper seating
- Bolt
- 7 Nm
- Air Duct Pipe
- Bolt
- 7 Nm
- Air Duct Pipe
- Bolt
- 7 Nm
- O-ring
- Is a component of the Charge Air Pressure Sensor -G31-
- Charge Air Pressure Sensor -G31-
- The Charge Air Pressure Sensor -G31- must be replaced after removing.
- Removing and installing. Refer to Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING .
- Air Duct Hose
- Installing. Refer to the illustration below.
NOTE:
The hose connections as well as air duct pipes and hoses must be free of oil and grease before installing.
Secure all hose connections with hose clamps that match the ones used in series production.
To safely secure the air duct hoses to their connections, spray the screws on the previously used screw-type clamps with rust remover.