RESIDUAL PRESSURE, CHECKINGTest Sequence:: Notes
Special tools and workshop equipment required
- Pressure Tester Kit:VAS6550
- Trim Removal Wedge:3409
- Vehicle Diagnostic Tester
Test Conditions:
- Voltage supply OK. Refer to Transfer Fuel Pump -G6-, CHECKING .
- Fuel pressure is OK. Refer to FUEL PRESSURE, CHECKING .
-- Follow all safety precautions. Refer to SAFETY PRECAUTIONS .
-- Follow the guidelines for clean working conditions. Refer to FUEL SYSTEM GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Connect the :VAS6550/2 between the fuel line from the fuel tank and the shut-off valve -B- on the :VAS6550 .
-- Connect the :VAS6550/1 between the fuel line leading to the engine and the shut-off valve -B- on the :VAS6550 .
-- Activate the fuel pump using the output diagnostic test mode to build the fuel pressure.
If the output diagnostic test mode is performed several times in succession, it may be necessary to briefly start the motor before repeating the output diagnostic test mode.
-- Read the fuel pressure on the pressure gauge.