Clamping Sleeve Installation Position
WARNING: This page is about a different car, the 2015 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Gradual introduction of clamping sleeves with continuous clamp.
Clamping sleeve -A- with two individual clamps.
Installation dimension -a- 5 mm (only for front clamping sleeve)
Clamping sleeve -B- with continuous clamp.
Installation dimension -a- 8.5 mm (only for front clamping sleeve)
1 - Clamping sleeve
2 - Front exhaust pipe
a - Installed dimension
A - Marking
-- Install the clamping sleeve so that the bolt end -arrow- does not project beyond the lower edge of clamping sleeve.
- Threaded connection points toward the right.
-- Install the clamping sleeve so that the bolt end -arrow- does not project beyond the lower edge of clamping sleeve.
- Threaded connection points to the rear
Tightening Specifications
- Refer to OVERVIEW - MUFFLER