Tightening Specifications
NOTE:
Always replace the intermediate sprocket. Otherwise the backlash will not adjust itself and it could result in engine damage.
The new intermediate sprocket has an anti-friction coating that wears off after a short period of use, which automatically adjusts the backlash.
-- Tighten with a new bolt as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1- | 10 Nm |
| 2. | -1- | The intermediate sprocket must not have any play. Loosen and tighten it again if necessary. |
| 3. | -1- | 25 Nm |
| 4. | -1- | Turn an additional 90°. |