LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Jetta GLI, Automatic DCT Trans >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Turbocharger System (Service Information - 1.8L; 2.0L TFSI - CPLA, CPPA, CPKA, CPRA) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING >> Removing

Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING: Removing

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

GWWM21-10014Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- and pull the Charge Air Pressure Sensor -G31- -1- out of the air duct pipe and remove it upward.

NOTE:

The bolts are each accessible in front of and behind the coolant hose from above.

scientia non olet · About LEMON Manuals