Overview - Fuel Delivery Unit, Hybrid
NOTE:
Hose connections are secured with either spring-type or clamp-type clips.
Replace the locking clamps with spring clamps.
Fuel hoses at engine must only be secured with spring-type clips. The use of clamp or screw type clips is not permissible.
The :VAS6340 are recommended for installing spring clamps.
- EVAP Canister System Pressure Sensor -G804-
- Make sure the connector and pressure sensor are seated securely
- Fuel Supply Line
- Black
- Attached to the side of the fuel tank
- To disconnect, press the release button on the connecting piece
- Connector Couplings, Disconnecting. Refer to CONNECTOR COUPLINGS .
- The connector couplings must >>audibly<< engage when locking.
- Check for secure fit
- Pull on the connector coupling to check for secure fit.
- Locking Ring
- 110 Nm
- Make sure it is secure
- Flange
- For the fuel delivery unit
- Fuel Level Sensor -G-
- Removing and installing. Refer to Fuel Level Sensor -G-, REMOVING AND INSTALLING, HYBRID .
- Fuel Delivery Unit
- Removing and Installing. Refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING .
- With the Transfer Fuel Pump -G6-
- Transfer Fuel Pump -G6-, Checking. Refer to FUEL PUMP .
- With the Fuel Gauge Sensor -G-
- Fuel Gauge Sensor -G-, Removing and Installing. Refer to Fuel Level Sensor -G-, REMOVING AND INSTALLING, HYBRID .
- Seal
- Replace after removing
- Install the dry seal into the opening in the fuel tank
- Moisten with fuel only when installing flange