LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Jetta GLI, Automatic DCT Trans >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels (Hood, Lids) (Service Information) JETTA >> (55 Hood, Lids) >> Rear Lid >> Latch, Removing And Installing >> Removing

Latch, Removing And Installing: Removing

GWWM55-10126Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If equipped, remove the cap -1- in the direction of the -arrow- while releasing the locking tab -2-.

NOTE:

If the rear lid does not open, use the emergency release -4- through the rear lid trim panel to open it manually. Refer to the approrpiate service/repair/system information.

The emergency release -4- is only installed in certain markets.

-- Remove the rear lid trim panel. Refer to LUGGAGE COMPARTMENT TRIM PANELS .

GWWM55-10045Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -3- from the latch -1-.

-- Remove the nuts -2- and remove the latch -1- from the rear lid.