LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Jetta GLI, Automatic DCT Trans >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels (Hood, Lids) (Service Information) JETTA >> (55 Hood, Lids) >> Rear Lid >> Hinges, Removing And Installing >> Removing

Hinges, Removing And Installing: Removing

GWWM55-10132Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If equipped, remove the left and right cover -1- from the hinge.

-- To do so, release the locking mechanisms -2- on the cover -1-.

-- Remove the cover -1- in the direction of the -arrow- from the hinge.

GWWM55-10067Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the rear lid -1-. Refer to REAR LID, REMOVING AND INSTALLING .

If removing the left hinge -6- :

-- Remove the wire -5- from the left hinge -6-.

If removing the right hinge -2- :

-- Remove the gas-filled strut -4- from the ball stud on the right hinge -2-. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING .

Continuation for both hinges:

-- Disengage the spring -3- -arrow- and remove it from the hinge.

-- Remove the rear shelf. Refer to LUGGAGE COMPARTMENT TRIM PANELS .

-- Remove the bolts -7-.

-- Remove the left hinge -2- or the right hinge -6-.