Monitor-ID $71: Secondary air injection system bank 1
-- CONNECT: Scan Tool
-- START ENGINE: Idle
-- SELECT: Mode 06
-- SELECT: "Monitor-ID $71"
-- SELECT: "Test-ID".
-- CHECK: values listed below at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $82 | P0491 | System test, Reduced secondary air mass | 0.0 | 1.999 | Refer to DTC P0491 in the DTC summary table. Engine Control Module --, 2016 MY => P0491 . |
| $85 | P0410 | Secondary air injection system test | 0.0 kPa | 5.0 kPa | Refer to DTC P0410 in the DTC summary table. Engine Control Module --, 2016 MY => P0410 . |
| $8C | P2440 | Secondary air injection valve functional test, Valve leak check | 0.0 | 1.34 | Refer to DTC P2440 in the DTC summary table. Engine Control Module --, 2016 MY => P2440 . |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition OFF.