Transmission Fluid Level, Checking: Notes

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Used Oil Collection and Extraction Unit:SMN372500
Oil Filler:VAS6262A
Also Oil Filler - Adapter 6:VAS6262/6 for some fluid containers
Vehicle Diagnostic Tester
Brake Line Tool Kit - Pipe Cutter:VAS6056/2

CAUTION:

This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.

Mandatory Replacement Parts

Seal - Transmission Fluid Drain - and Check Plug

Note the Following Information:

If the DSG^® transmission fluid is filled, only transmission fluid available as a replacement part may be used.
The :VAS6262/6 must also be used for some fluid containers.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
It may be necessary to shorten the bleed pipe on the :VAS6262A . Refer to TRANSMISSION FLUID LEVEL, CHECKING .

Shorten the Bleed Pipe on the:VAS6262A as Follows:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Shorten the pipe to dimension -a- so that the bleed pipe on the :VAS6262A will not touch the bottom on some fluid containers.

Dimension -a- = 210 mm

NOTE:

Dimension -a- is measured starting from the shaft of the :VAS6262A (green surface in the magnified area).

If dimension -a- is greater than 210 mm:

-- Make a mark on the bleed pipe, dimension -a-, and cut it, with for example the :VAS6056/2 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Requirements

The vehicle is level and all hoist supports are the same height.
Noise insulation is removed. Refer to NOISE INSULATION .
The Vehicle Diagnostic Tester is connected.
To begin working, the oil temperature must not be higher than 45 °C (113 °F).
Test temperature: 35 to 45 °C (95 to 113 °F)