Selector Lever Handle, Removing And Installing: Removing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the selector lever into "D" position.

It is not necessary to pull out the button -arrow- manually. The button locks in the installation position by itself when the handle is removed.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open the storage compartment door.

-- Grab under the shift cover by hand and by pulling upward unclip the cover.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector.

-- Cut the clamp under the boot -arrow- with a side cutter.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the knob up without pressing the button.

NOTE:

Do not push the button once the handle has been removed otherwise it will not be possible to remove the handle again.