LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Transmission System (Controls & Housing - Service Information - 6-Speed Dual Clutch - 0D9)) >> 34 Controls, Housing >> Selector Mechanism >> Selector Lever Handle, Removing And Installing >> Installing

Selector Lever Handle, Removing And Installing: Installing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following: 

NOTE:

It is possible that the button could be pressed into the handle. Never install the handle when the button is pressed in.

GWWN34-10549Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Move the button into the installation position. Refer to BUTTON IN HANDLE, MOVING INTO INSTALLATION POSITION .

A new handle is delivered with an assembly fastener. Pull out the retainer in the direction of -arrow- just before installing.

GWWN37-10434Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the handle with a new clamp -arrow-. Do not clamp the clamps yet.

GWWN34-11973Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the button after installation.

NOTE:

If the button stays in the handle after being pressed, this means it was installed incorrectly. If this happens, remove the handle again and move the button in the installation position again. Refer to BUTTON IN HANDLE, MOVING INTO INSTALLATION POSITION . Install the handle again.

-- If the button returns to its starting position after being pressed, the clamp can be fastened using the :VAG1275A  .

-- Connect the connector.

-- Clip on the cover.

scientia non olet · About LEMON Manuals