Fuel Pump Control Module -J538-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the front seats all the way forward.

-- Turn off the ignition.

-- Remove the rear bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .

-- Unclip the locking flange cover -1- at the tabs in direction of -arrows- using the :3409 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the grommet -1- downward out of the cover -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Guide the cover -2- on the wiring harness -3- downward.

-- Lift the tab -2- in direction of -arrow A- making it possible to reach between the floor panel and the fuel tank.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- At the same time, pull the Fuel Pump Control Module -J538- -1- on the wiring harness -3- in direction of -arrow B- carefully out of the mount.

-- Remove the Fuel Pump Control Module -J538- toward the inside between the fuel tank and the floor panel.

-- Disconnect the connector and remove the Fuel Pump Control Module -J538-.