Camshaft Housing - Tightening Specification And Sequence
WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
-- Tighten the bolts in the steps shown in the sequence:
| Step |
Bolts |
Tightening Specification |
| 1. |
-1 through 18- |
Install by hand all the way
- The camshaft housing contact surface must lay entirely on top of the cylinder head
|
| 2. |
-1 through 18- |
8 Nm |
| 3. |
-1 through 18- |
90° additional turn |