Cylinder Head - Tightening Specification And Sequence

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cylinder Head - Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in the steps shown in the sequence:

Step	Bolts	Tightening Specification/Additional Turn
1.	-1 through 10-	30 Nm
2.	-1 through 10-	65 Nm
3.	-1 through 10-	90° additional turn
4.	-1 through 10-	90° additional turn