LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Diesel Fuel Injection System (Service Information - CRUA)) >> 23 Diesel Fuel Injection >> Sensors >> Fuel Pressure Sensor -G247-, Removing And Installing >> Installing

Fuel Pressure Sensor -G247-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Check for damage to the sealing surfaces and threads on the Fuel Pressure Sensor -G247-. If the Fuel Pressure Sensor -G247- is OK, is it possible to re-use it.

Check the sealing surface on the high pressure reservoir opening.

Coat the Fuel Pressure Sensor -G247- threads and biting edge with diesel fuel.

-- Tighten the Fuel Pressure Sensor -G247- by hand.

-- Then tighten the Fuel Pressure Sensor -G247- to specification.

-- Fill/bleed the fuel system. Refer to FUEL SYSTEM, FILLING/BLEEDING .

-- Install the engine cover. Refer to ENGINE COVER .

scientia non olet · About LEMON Manuals