LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Diesel Fuel Injection System (Service Information - CRUA)) >> 23 Diesel Fuel Injection >> Sensors >> Exhaust Pressure Sensor 1 -G450-, Removing And Installing >> Installing

Exhaust Pressure Sensor 1 -G450-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal And Note The Following: 

NOTE:

Before installing the control lines leading from Exhaust Pressure Sensor 1 -G450- to the particulate filter, clean them with compressed air to make sure they are not plugged or iced over by condensation water.

Check The Hose For Secure Fit And Leaks.

Secure all hose connections with hose clamps that match the ones used in series production.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- After replacing the Exhaust Pressure Sensor 1 -G450- reset the adaption values. Refer to Vehicle Diagnostic Tester, Guided Functions  , 01 - Reset the adaptation values  .

scientia non olet · About LEMON Manuals