Differential Pressure Sensor -G505-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the engine cover. Refer to ENGINE COVER .
-- Open the heat shield boot -1-.
-- Disconnect the connector -4-.
-- Remove the bolt -3- and remove the Differential Pressure Sensor -G505- from the bracket.
-- Spray the hose on the Differential Pressure Sensor -G505- with solvent before removing.
-- Loosen the hose clamp -2-.
CAUTION:
There is a risk of damaging the differential pressure sensor by breaking the connection.
- Remove the hose carefully and evenly from the connection.