Differential Pressure Sensor -G505-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal And Note The Following:
NOTE:
Before installing, clean the control lines leading from the Differential Pressure Sensor -G505- to the particulate filter with compressed air to make sure they are not plugged or iced over with condensation water.
Check The Hose For Secure Fit And Leaks.
Secure all hose connections with hose clamps that match the ones used in series production.
-- Install the engine cover. Refer to ENGINE COVER .
It Is Necessary to Perform an Adaptation after Replacing the Differential Pressure Sensor -G505- and / or the Particulate Filter and the Adaptation Values Must Be Reset. The Adaptation Is Described under the Guided Functions. Refer to Vehicle Diagnostic Tester