Intake Manifold Bracket And Throttle Valve Control Module Bracket - Tightening Specification And Sequence

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Intake Manifold Bracket And Throttle Valve Control Module Bracket Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts in steps:

CAUTION:

When installing the intake manifold bracket and throttle valve control module bracket pay attention that the brackets are not installed under tension or at an angle.

Step	Bolts/Nuts	Tightening Specification
1.	-2, 3, 4, 7-	Install all the way by hand
2.	-2, 3, 4, 7-	Tighten to 20 Nm
3.	-5-	Tighten to 10 Nm
4.	-1-	Tighten to 10 Nm