Cooling System, Filling
WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Conditions:
- The needle on the pressure gauge -arrow- must move until it is well below the green area.
-- >>Slowly<< open the shut-off valve -A-, to prevent the foaming up of the coolant.
- Coolant is extracted from the :VAS6968 container by pressure in the coolant system and the system is filled.
-- Close after filling the shut-off valve -A-.
-- Remove the :VAS6096/2 , :VAS6096 and :VAS691005/5 from the coolant expansion tank.
-- Fill the coolant up to the weld seam -arrow- and seal the coolant expansion tank.
-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- If the vehicle has a parking heater, switch it on for about 30 seconds.
-- Set the temperature to "HI".
-- Press AC to turn off the A/C compressor.
- The LED in the button must not come on.