Heater Support Pump -V488-, Removing And Installing, Version 3: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

If The Heater Support Pump -V488- Should Be Removed:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release and remove the connector -arrow- from the Oil Level Thermal Sensor -G266-.

-- Then free up the wiring harness.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the :VAS6208 underneath.

-- Release and remove the connector -6-.

NOTE:

Place a cloth underneath to catch any escaping coolant.

-- Clamp off the coolant hoses -3 and 4- using the :3094 .

-- Loosen the lower hose clamps -arrows- at the Heater Support Pump -V488- and remove the coolant hoses.

-- Remove the bolt -2-.

-- Remove the Heater Support Pump -V488- -4- from the bracket -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

If The Heater Support Pump -V488- Is To Be Removed From The Engine Due To Lack Of Space:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release and remove the connector -arrow- from the Oil Level Thermal Sensor -G266-.

-- Then free up the wiring harness.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release and remove the connector -6-.

-- Remove the bolt -2-.

-- Move the Heater Support Pump -V488- -5- to the side.