Dual Clutch, Installing: Notes
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Clutch Retaining Bar:T10303
- Dial Gauge - 0-10mm:VAS6079
- Dial Gauge Holder:VW387
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Circlip - DSG® Clutch and Circlip
- Circlip
CAUTION:
- The drive plate of a new clutch is not secured with the circlip, it only sits "taut" in the clutch.
- Thus, press the drive plate into the outer clutch plate carrier with both thumbs during the following steps.
- The drive plate must remain engaged between the teeth of the outer clutch plate carrier.
- If the drive plate is loosened, the clutch plates can slip out of place and then the dual clutch may not be properly set during installation.