Dual Clutch, Installing: Installing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

A >>used<< clutch must not be installed again.

NOTE:

The drive plate circlip delivered in the replacement parts package will be installed later.

-- Remove the new drive plate circlip from the packaging and move to the side.

-- Take the dual clutch out of the packaging by pressing the drive plate into the outer clutch plate carrier with both thumbs.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the bottom of the dual clutch to see if the four hub gaskets are seated correctly and engage them in one another if necessary.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The ends of the rings should not stand over one another.

-- Turn the rings one time. They must move freely and must not stick.