Piston Projection, Measuring At TDC: Notes

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Measuring Bar:VW382/7 from the Special Socket & Measuring Tools:VW382
Measuring Set - Magnetic Plate - 50mm:VW385/17 from Measuring Set:VW385
Dial Gauge - 0-10mm:VAS6079

NOTE:

Check the piston projection at "TDC" whenever installing a new piston or a partial engine.

If varying values occur when measuring the piston projection, use the cylinder head gasket for the largest value.

Depending on the piston projection, install the cylinder head gasket according to the following table.